Child-Proof Lock - Beko WMB 51441 Mode D'emploi

Selecting or canceling an auxiliary
function in pause mode
Auxiliary functions can be cancelled or
selected in accordance with the step the
program is at.
Adding/removing laundry in pause mode
The door can be opened if the water level is
suitable. The door locked symbol will light
up until the door is suitable for opening. This
symbol will fade out as soon as the door is
allowed to open. Laundry may be added /
taken out by opening the door.
Door lock
The Door Locked Symbol lights up when the
loading door is locked. This symbol will flash
until the door is allowed to open. Do not force
the door at this stage. This symbol will fade
out as soon as the door is allowed to open.
You may open the door after the symbol fades
out.

Child-proof lock

Protect the appliance from being tampered
by children by means of the child-proof lock.
In this case, no change can be made in the
running program.
C Your machine can be turned on and off
with On/Off button while the child-proof
lock is activated. In this case, your machine
will resume its program with child-proof
lock activated.
The machine is switched to child-lock by
pressing the 2nd and 4th auxiliary functions
for 3 sec. "C:on" (Child-proof lock is activated)
label appears on the display.
The same symbol will also be displayed
whenever any button is pressed while the
machine is child-locked.
To deactivate the child-proof lock, press the
2nd and 4th auxiliary function buttons for 3
sec.
"C:OFF" (Child-proof lock is deactivated) label
appears on the screen.
Ending the program through canceling
"Start/Pause/Cancel" button (Figure 2-10) is
pressed for 3 seconds to cancel the program.
Start symbol (Figure 3-7j) will flash during
cancellation. After cancellation, the symbol
of the corresponding step at which the
cancellation was made will remain lit and "End"
will appear on the screen.
End of program
When the program is finished, the symbols
of the relevant steps will remain lit up and
the auxiliary function, spin and temperature
data selected at the start-up of the program
will remain selected. "End" will appear on the
display.
52 - EN