Audio Adjustments; Adjusting The Audio Easily; Adjusting The Audio Finely; Extra Functions - Pioneer DEH-P9600MP Mode D'emploi

Audio Adjustments

Adjusting the audio easily

The following functions let you easily adjust
your audio system to match the car interior
acoustic characteristics, which vary depend-
ing on the type of car.
! Recalling equalizer curves on page 44
! Using the position selector on the next page
! Adjusting equalizer curves on page 44

Adjusting the audio finely

By carrying out the following settings/adjust-
ments in the order shown, you can create a fi-
nely-tuned sound field effortlessly.
! Using the position selector on the next page
! Using balance adjustment on the next page
! Using subwoofer output on page 41
! Setting the high pass filter for front speakers
on page 43
! Setting the high pass filter for rear speakers
on page 43
! Auto TA and EQ (auto-time alignment and
auto-equalizing) on page 46
! Recalling equalizer curves on page 44
! Adjusting equalizer curves on page 44
! Adjusting 13-band graphic equalizer on page
45

Extra functions

These functions are helpful in adjusting the
sound to suit your system or your personal
preferences.
! Using BBE sound on page 45
! Adjusting loudness on page 45
! Using automatic sound levelizer on page 46
! Adjusting source levels on page 46
Introduction of audio
adjustments
1 Audio display
Shows the audio adjustments status.
1 Press OPEN to open the front panel.
2 Press AUDIO to display the first audio
function names.
Press AUDIO repeatedly to switch between
the following audio functions:
FAD/BAL (balance adjustment)POSITION
(position selector)TA.1 (time alignment set-
ting)TA.2 (time alignment adjusting)
LOUD (loudness)EQ1 (graphic equalizer)
EQ2 (13-band graphic equalizer)SW.1
(subwoofer on/off)SW.2 (subwoofer cut-off
frequency)SW.3 (subwoofer slope)BBE
(BBE)
3 Press AUDIO and hold until HP F1 ap-
pears in the display, then press AUDIO to
display the second audio function names.
After HP F1 is displayed, press AUDIO repeat-
edly to switch between the following audio
functions:
HP F1 (front high pass filter slope)HP F2
(front high pass filter cut-off frequency)
HP R1 (rear high pass filter slope)HP R2
(rear high pass filter cut-off frequency)
AUTO EQ (auto-equalizer on/off)ASL
(automatic sound levelizer)SLA (source level
adjustment)
# To return to the display of each source, press
BAND.
Section
08
1
39
En