Multi-Cd Player; Playing A Cd; Selecting A Track Directly - Pioneer DEH-P9600MP Mode D'emploi

Section
07

Multi-CD Player

Playing a CD

You can use this unit to control a multi-CD
player, which is sold separately.
These are the basic steps necessary to play a
CD with your multi-CD player. More advanced
CD operation is explained starting on the next
page.
1 Disc number indicator
Shows the disc currently playing.
2 Track number indicator
Shows the track currently playing.
3 Play time indicator
Shows the elapsed playing time of the cur-
rent track.
1 Press SOURCE to select the multi-CD
player.
Press SOURCE until you see Multi-CD dis-
played.
2 Use VOLUME to adjust the sound level.
Rotate it to increase or decrease the volume.
3 Select a disc you want to listen to with
the 16 buttons.
For discs located at 1 to 6, press the corre-
sponding button number.
If you want to select a disc located at 7 to 12,
press and hold the corresponding numbers,
such as 1 for disc 7, until the disc number ap-
pears in the display.
32
En
# You can also sequentially select a disc by
pressing a/b.
1 2
4
press and hold c or d.
5
track, press c or d.
Pressing d skips to the start of the next track.
3 Pressing c once skips to the start of the cur-
rent track. Pressing again will skip to the pre-
vious track.
! When the multi-CD player performs the pre-
! If the multi-CD player does not operate prop-
! If there are no discs in the multi-CD player ma-

Selecting a track directly

When using the remote control, you can select
a track directly by entering the desired track
number.
1
Track number input display appears.
2
sired track number.
# You can cancel the input number by pressing
CLEAR.
3
The track of entered number will play.
To perform fast forward or reverse,
To skip back or forward to another
Notes
paratory operations, Ready is displayed.
erly, an error message such as ERROR-11
may be displayed. Refer to the multi-CD player
owners manual.
gazine, No disc is displayed.
Press DIRECT.
Press NUMBER buttons to enter the de-
Press DIRECT.