Using The Auto-Equalizer; Recalling Equalizer Curves; Adjusting Equalizer Curves - Pioneer DEH-P9600MP Mode D'emploi

Section
08 Audio Adjustments

Using the auto-equalizer

The auto-equalizer is the equalizer curve cre-
ated by auto TA and EQ (refer to Auto TA and
EQ (auto-time alignment and auto-equalizing)
on page 46).
You can turn the auto-equalizer on or off.
1 Press AUDIO and hold until second
audio menu appears in the display, then
press AUDIO to select AUTO EQ.
After second audio menu is displayed, press
AUDIO until AUTO EQ appears in the display.
2 Press a to turn the auto-equalizer on.
Auto EQ ON appears in the display.
# To turn auto-equalizer off, press b.
# Please set Auto EQ appears. This indicates
that you cannot turn the auto-equalizer on if auto
TA and EQ has not been carried out.

Recalling equalizer curves

The equalizer lets you adjust the equalization
to match car interior acoustic characteristics
as desired.
There are seven stored equalizer curves which
you can easily recall at any time. Here is a list
of the equalizer curves:
Display
SUPER BASS
POWERFUL
NATURAL
VOCAL
FLAT
CUSTOM1
CUSTOM2
! CUSTOM1 and CUSTOM2 are adjusted
equalizer curves that you create. Adjust-
44
En
Equalizer curve
Super bass
Powerful
Natural
Vocal
Flat
Custom 1
Custom 2
ments can be made with a 13-band graphic
equalizer.
! When FLAT is selected no supplement or
correction is made to the sound. This is
useful to check the effect of the equalizer
curves by switching alternatively between
FLAT and a set equalizer curve.
% Press EQ to select the equalizer.
Press EQ repeatedly to switch between the fol-
lowing equalizers:
SUPER BASSPOWERFULNATURAL
VOCALFLATCUSTOM1CUSTOM2

Adjusting equalizer curves

The factory supplied equalizer curves, with the
exception of FLAT, can be adjusted to a fine
degree (nuance control).
1 Press AUDIO to select EQ1.
Press AUDIO until EQ1 appears in the display.
2 Press c or d to select an equalizer
curve.
3 Press a or b to adjust the equalizer
curve.
Each press of a or b increases or decreases
the equalizer curve respectively.
+6  5 (or 6) is displayed as the equalizer
curve is increased or decreased.
# The actual range of the adjustments are differ-
ent depending on which equalizer curve is se-
lected.
# The equalizer curve with all frequencies set to
0 cannot be adjusted.