Built-In Cd Player; Playing A Cd - Pioneer DEH-P9600MP Mode D'emploi

Built-in CD Player

Playing a CD

These are the basic steps necessary to play a
CD with your built-in CD player. More ad-
vanced CD operation is explained starting on
the next page.
1 Track number indicator
Shows the track currently playing.
2 Play time indicator
Shows the elapsed playing time of the cur-
rent track.
1 Press EJECT.
CD loading slot appears.
# After a CD has been inserted, press SOURCE
to select the built-in CD player.
2 Insert a CD into the CD loading slot.
Playback will automatically start.
CD loading slot
EJECT button
# You can eject a CD by pressing EJECT.
# If the front panel is in the eject position
(shown above), buttons other than EJECT,
VOLUME, OPEN, and ATT (on the remote con-
trol) do not operate.
3
Rotate it to increase or decrease the volume.
1
4
press and hold c or d.
# If you select Rough search, pressing and
holding c or d enables you to search every 10
tracks in the current disc. (Refer to Selecting the
search method on page 22.)
2
5
track, press c or d.
Pressing d skips to the start of the next track.
Pressing c once skips to the start of the cur-
rent track. Pressing again will skip to the pre-
vious track.
! The built-in CD player plays one, standard, 12-
cm or 8-cm (single) CD at a time. Do not use
an adapter when playing 8-cm CDs.
! Do not insert anything other than a CD into
the CD loading slot.
! There is sometimes a delay between starting
up CD playback and the sound being issued.
When being read in, Format read is dis-
played.
! If you cannot insert a disc completely or if
after you insert a disc the disc does not play,
check that the label side of the disc is up.
Press EJECT to eject the disc, and check the
disc for damage before inserting it again.
! If the built-in CD player does not operate prop-
erly, an error message such as ERROR-11
may be displayed. Refer to Understanding
built-in CD player error messages on page 58.
! You can eject the CD by pressing and holding
EJECT with eject position when the CD load-
ing or ejecting cannot operate properly.
Use VOLUME to adjust the sound level.
To perform fast forward or reverse,
To skip back or forward to another
Notes
Section
05
19
En