Audio Adjustments; Introduction Of Audio Adjustments; Compensating For Equalizer Curves (Eq-Ex) - Pioneer SUPER TUNER IIID DEH-P80MP Mode D'emploi

Audio Adjustments

Introduction of audio
adjustments
1
1 Audio display
Shows the audio adjustments status.
1 Press Multi-Control to display the main
menu.
FUNCTION and AUDIO appear on the display.
2 Use Multi-Control to select AUDIO.
Turn to change the menu option; press to se-
lect.
The audio function name appears on the dis-
play.
3 Turn Multi-Control to select the audio
function.
Turn Multi-Control clockwise to switch be-
tween the audio functions in the following
order:
Fad (balance adjustment)EQ (equalizer
curve adjustment)F 80 Q 1W (equalizer
curve fine adjustment)Bass (bass and treble
level adjustment)Bass (bass and treble fre-
quency adjustment)Loud (loudness)
Sub-W1 (subwoofer on/off setting)/NonFad
(nonfading output on/off setting)Sub-W2
(subwoofer setting)/NonFad (nonfading out-
put setting)HPF (high pass filter)SLA
(source level adjustment)ASL (automatic
sound levelizer)
# If EQ-EX function has been selected and only
when EQ-EX is turned on and CUSTOM is se-
lected as the equalizer curve, you can switch to
Bass.
# When the subwoofer controller setting is only
PREOUT:FULL, you cannot switch to Sub-W1.
(Refer to page 55.)
# You can select the Sub-W2 only when sub-
woofer output is turned on in the Sub-W1.
# When the subwoofer controller setting is only
PREOUT:FULL, you can switch to the nonfading
output on/off setting. (Refer to page 55.)
# You can select the nonfading output setting
only when nonfading output is turned on in the
nonfading output on/off setting.
# When selecting the FM tuner as the source,
you cannot switch to SLA.
# To return to the display of each source, press
BAND.
Note
If you do not operate the audio function within
about 30 seconds, the display is automatically re-
turned to the source display.
Compensating for
equalizer curves (EQ-EX)
The EQ-EX function smoothes the effects of
each equalizer curve. Furthermore, you can
adjust bass and treble for each source when
CUSTOM curve is selected.
! If SFEQ has been previously selected, press
EQ-EX and hold until EQ-EX indicator ap-
pears in the display.
% Press EQ-EX to turn EQ-EX on.
EQ-EX ON appears in the display. EQ-EX is
now on.
# To turn EQ-EX off, press EQ-EX.
Section
11
47
En