Panasonic TY-CE85PS12 Manuel D'installation page 18

Prior to installation work
Never use any other method than specified to install.
1. Check the strength of the installation location.
The ceiling-hanging bracket weighs about 35 kg (77.2 lbs.).
For the mass of the display to be installed on the ceiling unit, refer to the instruction manual for the
Plasma Display.
Caution
Before installing the ceiling unit, check the installation location of the ceiling for strength. If the installation
location is not strong enough, reinforce the ceiling adequately.
※ Refer to page 124 for the detailed dimensions that apply when installing the plasma display.
2. Prepare the Plasma Display.
18
Cap
1. Place the hook of lifting equipment in the display's
2. Remove the two caps (at the top) from the rear
Stand hooks
3. Unscrew the stand hooks (in 2 places on each side)
※ Keep the caps, stand hooks, spring washers and
Caution
Because the display is heavy, handle it carefully by the
use of lifting equipment (machine).
The display has the operation part on its right side face.
Do not bump the operation part against any things
located around, during installation.
center eyebolt, lift up the display, and put it on soft
stuff such as a blanket.
(The display should be kept in an upright position.)
panel of the plasma display.
with the Allen wrench supplied with the plasma
display.
Hexagon socket head button bolt which have been
removed in a safe place.