Switching The Soundbar On/Off; Switching The Subwoofer On/Off; Connecting The Soundbar And Subwoofer - Medion Dolby Atmos LIFE S61388 Notice D'utilisation

8.2. Switching the soundbar on/off
 Switch on the soundbar by pressing and holding the
control or the soundbar.
The soundbar switches on and starts. This process takes several seconds,
during which time ON flashes on the display. As soon as the soundbar
has started fully, the last selected source is shown on the display.
If a TV or an external device is connected via the AUX socket or HDMI
ports, the soundbar will switch on automatically a few seconds after the
television or the external device is switched on.
If the TV or the external device is disconnected or switched off, the
soundbar will switch off automatically after approximately 15 minutes.
If the volume of the television or external device is set too low, the
soundbar will also switch off after approximately 15 minutes (but only if
the devices are connected via AUX).
 When the device is in use, press and hold the
the remote control to switch the soundbar into standby mode.
8.3. Switching the subwoofer on/off
 Set the on/off switch on the back of the subwoofer to I to switch on the
subwoofer.
 Set the on/off switch on the back of the subwoofer to 0 to switch off the
subwoofer.

8.4. Connecting the soundbar and subwoofer

The soundbar and subwoofer connect automatically the first time they are used.
Once the connection is successful, the Pairing LED on the back of the subwoofer
lights up blue continuously.
If the Pairing LED is flashing, the automatic connection has failed. To connect the
devices manually, proceed as follows:
 Switch on the soundbar and the subwoofer.
 Press and hold the PAIR button on the back of the subwoofer until the Pairing
LED flashes quickly.
 Next, press and hold the VERTICAL SOUND button on the remote control until
the connection process starts and SW P is shown on the soundbar display.
The Pairing LED lights up blue continuously as soon as the connection between
the soundbar and subwoofer has been established successfully.
If the subwoofer is switched on after the soundbar, it always starts with
the bass level set to 30% by default. Use the
set the desired bass level.
button on the remote
button on the soundbar or on
and
DE
EN
FR
NL
IT
ES
buttons to
59