Operations Using The On-Screen Bar - JVC KD-ADV5580 Manuel D'instructions

• For MPEG Video/MP3/WMA/WAV, track is searched
within the same folder.
• For DVD-VR, program/playlist search is possible
during Original program playback (PG)/Playlist
playback (PL).
• To erase a misentry, press CLR (clear) while holding
SHIFT.
• To return to the previous screen, press RETURN.
Using menu driven features... (DVD-Video/
DVD-VR)
1
Press TOP MENU/DVD MENU to enter the menu
screen.
% fi @ #
2
Press / / / to select an item you want to
start play.
3
Press ENT (enter) to confirm.
Canceling the PBC playback... (VCD)
1
During stop, press DIRECT while holding SHIFT.
2
Hold SHIFT, then press the number buttons (0 – 9)
to enter the desired number.
3
Press ENT (enter) to confirm.
• To resume PBC, press TOP MENU/DVD MENU.
18
Operations using the
on-screen bar
(DVD/DVD-VR/MPEG Video/VCD)
These operations are possible on the monitor using the
remote controller.
1
Show the on-screen bar (see page 19).
(twice)
2
Select an item.
3
Make a selection.
If pop-up menu appears...
• To cancel pop-up menu, press RETURN.
• For entering time/numbers, see the following.
Entering time/numbers
% fi
Press / to change the number, then press
move to the next entry.
%
• Each time you press /
decreases by one value.
• After entering the numbers, press ENT (enter).
• It is not required to enter the zero and tailing zeros
(the last two digits in the example below).
Ex.: Time search
DVD: _:_ _:_ _ (Ex.: 1:02:00)
% #
Press once, then twice to go to the third entry,
twice, then press ENT (enter).
Removing the on-screen bar
@ #
/
fi
, the number increases/
to
%