Safety Instructions; Intended Use - Gesipa PowerBird Mode D'emploi

GB
MEGA GRIP
®
Rivet material
Ø (mm)
Al/Al, steel/steel,
4.8
stainless steel
Al/Al, steel/steel,
6.4
stainless steel
MG = MEGAGRIP
®
* available as special accessory. Elongated nosepieces and other special nosepieces are
available on request.
1.5

Safety instructions

Caution:
Following safety rules must be followed for adequate protection against electrical schock, inju-
ries or fire hazards:
The riveting tool should be used exclusively to set blind rivets.
• Do not overload the tool; Work within the prescribed work capacity.
• Do not expose the tool to humidity or rain, do not operate the tool close to inflammable sub-
stances or gases: Risk of explosion!
• Ensure that the battery is properly secured in the tool handgrip.
• Remove the battery when the tool is not in use and for repair/servicing operations.
• Do not use the tool as a hammer.
• When not in use, keep the tool in a dry closed room, out of reach of children.
• When working with the tool, always carry protection goggles. Personal protection like
clothes, gloves, safety helmet, non slipping shoes, ear protectors and protection against
fall are highly recommended.
• The air inlets for the engine should not be ob structed. Do not introduce anything into them.
• When depositing the tool, make sure that it cannot fall down.
• Use only genuine spare parts for repair.
• Repair work must be carried out by skilled personal. In case of doubt, always send back the
tool to the manufacturer!
• Do not use the tool outside of riveting holes.
The blind rivet could be ejected from the tool. Never turn the tool towards yourself or
towards another person.
• Mandrel container (Part N° 32) must be mounted on the tool during operation.
1.6

Intended use

• Engage fully charged battery in correct position into housing.
• Select correct nosepiece (according to table 1.4.) and screw into head.
• Attention: Do not cover the vent holes and do not obstruct the vent holes.
21
Nosepiece Part No.
17/31 MG* 143 4993
17/41 MG* 143 4865
Jaw
Part No.
pusher
5 143 4872
5 143 4861
Jaws Part No.
4 143 4240