Introduction; Features; Technical Specifications - Bentel Security BGSM-G/AM Mode D'emploi

The BGSM-G is a backup wireless communicator that sends alarm system information to a System III or System II receiver, or a PC with
WinBCS (2.0 or higher), through a GSM/GPRS wireless network. The BGSM-G is available in two models that are different for the
operating frequency only: BGSM-G/AM = 850/1900 MHz; BGSM-G/EU = 900/1800 MHz.
This manual provides programming and operating instructions for both the BGSM-G GSM/GPRS alarm communicators. Information
relating to a specific model will be denoted by the applicable model number within the text. The term "Device" is used to describe
functionality that is applicable to both models.
, , , , , This Device is fixed and shall be installed by Service Persons only (service person is defined as a person having the
appropriate technical training and experience necessary to be aware of hazards to which that person may be exposed
in performing a task and of measures to minimize the risks to that person or other persons). It shall be installed and
used within an environment that provides the pollution degree max 2, over voltages category II, in non-hazardous,
indoor locations only. This manual shall be used with the Installation Manual of the alarm control panel. All instruc-
tions specified within that manual must be observed.

Features

€ Simulates land line
€ Switches automatically to GSM Network in the event land line
trouble (line down)
€ Manages and signals Incoming/Outgoing calls
€ GSM signal indicator
€ 4 programmable OC Outputs
€ Houses 12 V / 1.2 Ah battery (optional)
€ Tamper protection contact
€ Land line overvoltage protection
€ Dual-Band
€ 4 Input Lines
€ SMS Alerts

Technical Specifications

The input voltage to this Device can be drawn from the Control Panel or provided by the ADP1512 power supply (optional).
'HVFULSWLRQ
,QSXW 9ROWDJH
&XUUHQW
%DWWHU\
6WDQGE\ FXUUHQW
$ODUP 7UDQVPLWWLQJ FXUUHQW
2XWSXWV
2SHUDWLQJ IUHTXHQF\
$QWHQQD *DLQ
0D[LPXP ORRS UHVLVWDQFH RI OLQH
EHWZHHQ WKH GHYLFH FRQQHFWHG LQ VHULHV RQ /,
0D[LPXP QXPEHU RI SDUDOOHO GHYLFHV
FRQQHFWHG RQ /,
2SHUDWLQJ 7HPSHUDWXUH
'LPHQVLRQV
:HLJKW ZLWKRXW EDWWHU\
18

INTRODUCTION

€ Supports Contact ID communication format from a connected
€ GPRS/Internet communication with Sur-Gard System III / II
€ 13 SMS Messages (2 messages per Input Line and 5 Status
€ 8 phone numbers (max. 20 digits) programmable for SMS Dialer
€ 4 phone numbers programmable for Contact ID Dialer
€ Up to 95 phone numbers (max. 20 digits) can be programmed
€ Remote control of the OC Outputs via SMS and/or over-the-
%*60*$0
WR HQVXUH FRPSDWLELOLW\ ZLWK RXU SDQHOV DQG SRZHU VXSSOLHV
 P$ -3 2)) DQG LQWHUQDO EDWWHU\ UHTXLUHG
VHDOHG UHFKDUJHDEOH W\SH UDWHG  9   $K
 DYDLODEOH RSHQ FROOHFWRU W\SH VZLWFKHG WR JURXQG
  0+]
 [  [  PP   [  [  LQFK
control panel for communication over the GPRS network
messages)
to manage remote control of the OC Outputs
phone after caller recognition
 9
RU  P$ -3 21
 P$
 P$
UDWHG  P$
 G%
 .RKP

 WR  ƒ&   WR  ƒ)
 J   R]
GSM/GPRS Alarm Communnicator
%*60*(8
“
 0+]