Panasonic EYFPA1J Instructions D'utilisation page 19

[Battery Pack]
For Appropriate Use of Bat­
tery Pack
[Fig.28]
• The rechargeable batteries have a limited
life.
• For optimum battery life, store the Li-ion bat-
tery pack following use without charging it.
• When operating the battery pack, make sure
the work place is well ventilated.
For safe use
• The battery pack is designed to be installed
by proceeding two steps for safety. Make
sure the battery pack is installed properly to
the main unit before use.
• If the battery pack is not connected firm-
ly when the switch is switched on, the over-
heat warning lamp and the battery low warn-
ing lamp will flash to indicate that safe oper-
ation is not possible, and the main unit will
not rotate normally. Connect the battery
pack into the unit of the tool until the red or
yellow label disappears.
Battery Recycling
ATTENTION:
A Li-ion battery that is recyclable powers
the product you have purchased.
Please call 1­800­8­BATTERY for infor-
mation on how to recycle this battery.
[Battery Charger]
Charging
Read the operating manual for Panasonic bat-
tery charger for the battery pack before charg-
ing.
Before charging the battery
Charge the battery at a temperature of °C
(41°F) to 40°C (104°F).
The battery pack cannot be charged at a
tem perature of less than °C (41°F). If the
tem perature of the battery pack is less than
°C (41°F), fi rst remove the battery pack from
the charger and allow it to sit for an hour in a
location where the temperature is °C (41°F)
or warmer. Then charge the battery pack
again.
VI
. MAINTENANCE
• Use only a dry, soft cloth for wiping the unit.
Do not use a damp cloth, thinner, benzine,
or other volatile solvents for cleaning.
• Regular greasing is recommended.
Contact your nearest dealer or service cen-
ter.
- 1 -
EN EN