Cleaning And Maintenance - IKEA VÄRMA Mode D'emploi

ENGLISH

Cleaning and maintenance

Cleaning is the only maintenance normally
required.
Failure to maintain the oven in a clean
condition could lead to deterioration of the
surface that could adversely affect the life
of the appliance and possibly result in a
hazardous situation.
IMPORTANT: do not use metal
i
scouring pads, abrasive cleansers,
steel-wool pads, gritty washcloths, etc.
which can damage the control panel, and
the interior and exterior oven surfaces. Use
a sponge with a mild detergent or a paper
towel with spray glass cleaner. Apply spray
glass cleaner to a paper towel.
Do not spray directly on the oven.
At regular intervals, especially if spill overs
have occurred, remove the turntable, the
turntable support and wipe the base of the
oven clean.
This oven is designed to operate with the
turntable in place.
IMPORTANT: do not operate the
i
microwave oven when the turntable
has been removed for cleaning.
Use a mild detergent, water and a soft cloth
to clean the interior surfaces, front and rear
of the door and the door opening.
IMPORTANT: do not allow grease or
i
food particles to build up around the
door.
For stubborn stains, boil a cup of water
in the oven for 2 or 3 minutes. Steam will
soften the marks.
IMPORTANT: do not use steam
i
cleaning appliances when cleaning
your microwave oven.
Adding some lemon juice to a cup of water,
placing this on the turntable and boiling for
a few minutes can eliminate odors inside the
oven.
The Grill element does not need cleaning
since the intense heat will burn off any
splashes, but the cavity ceiling near it may
need regular cleaning. This should be done
with warm water, detergent and a sponge.
If the Grill is not used regularly, it should be
run for 10 minutes a month to burn off any
splashes.
Dishwasher safe
• Turntable support.
• Glass turntable.
• Crisp handle.
Careful cleaning
The Crisp-plate should be cleaned in mild,
detergent water. Heavily soiled areas can
be cleaned with a scouring sponge and a
mild cleanser.
Always let the crisp-plate cool off before
cleaning.
IMPORTANT: do not immerse or rinse
i
with water while the crisp-plate is hot.
Quick cooling may damage it.
IMPORTANT: do not use steel-wool
i
pads. This will scratch the surface.
During and after use, do not touch the
heating elements or interior surface of the
appliance - risk of burns. Do not allow the
appliance to come in contact with cloths
or other flammable materials until all the
components have cooled down completely.
The appliance must be disconnected from
the power supply before carrying out any
cleaning or maintenance operation.
Use protective gloves for cleaning and
maintenace operations.
Ensure the appliance is cooled down before
carrying out any cleaning or mainteinance
operation.
19