Before Using For The First Time; Symbols And Markings; Preparation - Bosch MUZ4GM3 Mode D'emploi

en
Overview
Overview
Fig. A
1 Housing
a Setting ring
b Marking Ä
c Scale for grinding level
1 = fine
6 = coarse
d Marking <
e Marking t
f Discharge chute
g Drive coupling
2 Grinding cone
3 Grinding ring
a Marking Ü
4 Filling tray
a Scale for fill level
Before using for the first
time
Before the new accessory can be used,
it must be fully unpacked, cleaned and
checked.
Caution!
Never operate a damaged accessory!
■ Remove all accessories from the
packaging and dispose of all packing
materials.
■ Check that all the parts are present and
examine them for obvious damage.
X Fig. A
■ Thoroughly clean and dry all parts
before using for the first time. X "Clean-
ing and maintenance" see page 9
8

Symbols and markings

Symbol Meaning
W
Caution! Rotating tools. Do not
reach into the feed chute.
t
Marking for reading setting
Removing / inserting
Ä
grinding ring
Scale for grinding level
1 .... 6
Setting 1 (fine) to 6 (coarse)
Caution! Blocking of
<
grinding unit.
Ü
Inserting grinding ring

Preparation

■ Place the base unit on a flat, clean
surface.
■ Insert the bowl with lid.
■ Press the Release button and
move the swivel arm to posi-
tion 2. Remove the protective
drive cover.
Assembling the mill
X Image sequence B
1. Turn the setting ring in an anticlockwise
direction to the stop. Markings Ä
and t must match up exactly. Place
the grinding cone on the square shaft
in the housing and press right down.
2. Insert the grinding ring in the housing.
Markings Ü, Ä und t must match up
exactly.
Note: It is only possible to insert and
remove the grinding ring properly when in
this position.
3. Press the grinding ring down lightly
and turn the setting ring in a clockwise
direction until the scale for the grinding
level is reached.
4. Attach the filling tray.