Overload Protection - Bosch MUZ4GM3 Mode D'emploi

en
Tips
■ Clean the mill as described under
„Assembling the mill" but in reverse
order. X "Assembling the mill" see
page 8
■ Only clean the grinding ring and grinding
cone with a dry brush.
■ Do not clean the housing in rinsing
water. Only wipe the outside with
a damp cloth.
■ Move the discharge chute out of the way
for cleaning.
■ Store the mill in a dry place.
Tips
Dry storage
Moist grains produce abnormal levels of
heat. This is clearly indicated when the
grinding zone of the steel cone grinder
becomes clogged, so preventing fine
grinding. If the appliance has difficulty
in fine-grinding the grain, this may indicate
that the grain is too moist. Therefore store
the ingredients uncovered in a dry place
or in a jute sack. The storage temperature
must not exceed 40° C.
Note: Grain is a natural "preserved food"
and hygroscopic. Users must therefore
always be reminded that it should be
stored dry.
Moisture test
A simple test is to crush the ingredients
between two hard objects. Unsuitable,
i.e. excessively moist ingredients, can
be flattened like oats and will not crack.
If necessary, dry again. Another way of
testing this is to put some of the ingredi-
ents in the freezer for several hours and
then immediately process them on a fine
grinding setting. If the frozen grain can be
ground finely, this is a clear indication that it
was previously too moist.
10

Overload protection

An installed predetermined breaking point
protects the drive from damage. The drive
coupling will break if an overload occurs
(e.g. moist ingredients or foreign object in
the grinder). A replacement drive coupling is
available from a dealer or customer service
(order no. 00031003). The drive coupling
can easily be removed and replaced.
X Image sequence D
1. Turn the setting ring in a clockwise
direction to the marking <.
The grinding unit is blocked.
2. Grasp the drive coupling by its faces
with flat-nosed pliers, rotate clockwise
and remove (bayonet fixing).
Subject to change without notice.