Automatic Icemaker; Preparing For Vacation; Normal Sounds You May Hear - GE IM4D Manuel D'utilisation Et Instructions D'installation

Automatic Icemaker

A newly-installed refrigerator may take 12 to 24 hours to begin making ice.
The icemaker will produce seven cubes per cycle-
approximately 100-130 cubes in a 24-hour period,
depending on freezer compartment temperature, room
temperature, number of door openings and other use
conditions.
Sensor

Preparing for Vacation

Set the icemaker power switch to OFF and shut off the
water supply to the refrigerator.
When you should set the icemaker power switch to OFF
minute or two.
hours.

Normal sounds you may hear

ON position, it will buzz even if it has not yet been
hooked up to water. Keeping the power switch in
the ON position before it is hooked up to water can
damage the icemaker. To prevent this, move the
power switch to the OFF position. This will stop the
buzzing.
4
Feeler Arm
Power
Switch
is made to the icemaker, set the power switch to OFF.
When the refrigerator has been connected to the water
supply, set the power switch to ON.
The icemaker will fill with water when it cools to freezing.
A newly-installed refrigerator may take 12 to 24 hours to
begin making ice cubes.
You will hear a buzzing sound each time the icemaker
fills with water.
Throw away the first few batches of ice to allow the
water line to clear.
Be sure nothing interferes with the sweep of the feeler
arm.
When the bin fills to the level of the feeler arm, the
icemaker will stop producing ice.
cloudy, taste stale and shrink.
IM4LED only:
activated by a motion sensor when the freezer door is
opened.
some models) to prevent serious property damage due
to flooding.
days.
running in the pipes as the icemaker refills.
49-60698-4