Water Line Installation - GE IM4D Manuel D'utilisation Et Instructions D'installation

WATER VALVE INSTALLATION INSTRUCTIONS T - IM4D ONLY
BEFORE YOU BEGIN
Read these instructions completely and carefully.
WARNING
To reduce the risk of
electric shock or injury during installation,
you must first unplug the refrigerator
before proceeding. Failure to follow
these instructions can result in electrical
shock.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
REMOVE THE COVER
1
to remove the compressor compartment access
attach the cover to the back of the refrigerator
case.
Be sure to save the screws as the access
cover must be reinstalled later to ensure your
refrigerator will function properly.
WARNING
To reduce the risk of death or
electric shock, you must follow these
instructions:
Unplug the refrigerator before removing any
panels.
Do not damage any wiring while the panel is
removed.
Replace all parts and panels before plugging
the refrigerator back in.
14
Installation Instructions
Sharp knife
Pliers
PLASTIC WATER TUBING
2
from the clip and pushing on the bottom of the
pulling it from the valve.
Clip
Water line
that came with the refigerator. The water line
is attached to the fill tube assembly that is
the water line through the clip on the valve
The white line will
be barely visible
if properly
engaged.
Clip
Water line
ATTACH THE BRACKET
3
EXTENSION TO THE WATER
VALVE
Bracket
nutdriver to extension
attach the
16
bracket extension
valve bracket
with the screw
Quick-connect
Push up
Pull down
Quick-connect
17
49-60698-4