Water Valve Assembly Installation U, V, W; Water Valve Assembly - GE IM4D Manuel D'utilisation Et Instructions D'installation

WATER VALVE ASSEMBLY INSTALLATION INSTRUCTIONS
(Continued)
CONNECT WATER TUBE
3
TO INLET (cont.)
can go and the hose clamp is not in place over
the fill tube assembly, then leaks are possible.
INSTALL WATER LINE CLAMP
4
WARNING
Attach tubing clamp using existing hole only. DO
NOT drill into the refrigerator.
metal water
line clamp (strain relief)
Drive the screw
the kit through the clamp
the back of the cabinet.
water valve up to the inlet.
Small indent for water
line clamp installation
49-60698-4
Installation Instructions
adhesive-backed fasteners
ELECTRIC SHOCK
HAZARD
5
ROUTE AND ATTACH THE
5
WATER TUBE
refrigerator with adhesive-backed fasteners
slack in the tube.
WATER VALVE INSTALLED
6
6
for connection to the home water supply. After
water line installation is completed, set the
icemaker power switch to ON.
The icemaking cycle will not begin until the
icemaker and freezer compartment reach
operating temperature, then icemaking will
begin automatically.
REINSTALL THE COVER
removed previously to reattach the cover to
the back of the refrigerator case. This must
be reinstalled for your refrigerator to function
properly.
Adhesive-backed
fasteners for water tube
13