Prepare For Installation - GE IM4D Manuel D'utilisation Et Instructions D'installation

ICEMAKER INSTALLATION INSTRUCTIONS (Continued)
REMOVE THE OUTLET COVER
3
Peel off the outlet cover.

PREPARE FOR INSTALLATION

4
leave them in place.)
in the rear freezer wall.
screwdriver.
or leave screws in place
plug button
models)
8
Installation Instructions
REMOVE ONLY
TO INSTALL
WATER FILL TUBE
Outlet
cover
INSTALL FILL TUBE
5
Go to the back of the refrigerator. On the
refrigerator side of the fill tube assembly
12 depending on model), there is an adhesive
the tube into the hole near the top at the back
of the refrigerator. Firmly press on the fill tube
assembly to secure it to the refrigerator.
SET POWER SWITCH TO OFF
6
Set the icemaker power switch to OFF
the power switch in the OFF position until the
refrigerator
is connected
to the water
supply to
prevent
Power
Switch
premature
operation.
INSTALL THE ICEMAKER
FILL CUP
For letters U & V
icemaker fill cup
icemaker as shown.
For letter W
icemaker fill cup that came with your
fill cup has been misplaced, call 1.800.626.2002
cup is not installed into the icemaker, there is the
possibility of water leaking into the freezer and
not into the icemaker.
11 or 12
13
may vary)
49-60698-4