Change Batteries For The Remote Control - American Standard SpaLet Advanced Clean 2.5 Manuel D'installation

Change Batteries for the Remote Control

When batteries are about to run out, the battery indicator LED
display begins to flash.
The indicator only flashes when batteries are low.
The batteries included were used in testing of product and
may not have the normal lifecycle.
The lighting in the room area may make it difficult to see
the low battery LED flashing.
Change new batteries for the remote control; as follows.
Cautions
The + and - of the battery shall comply with the marks on the remote control
Do not mix the new battery with the used ones.
Use alkaline batteries.
Do not touch the switches or buttons on the remote control when
changing batteries.
Pull the remote control up and
take it out from the bracket.
Place the cover back and the remote control into the bracket.
Change Batteries for the Remote Control
Remote
Control
Bracket
32 - EN -
Open the rear cover of the battery
compartment and place 2-AA batteries
e
Buckle
Alkaline Dry
Battery
Rear
Cover