Grounding Instructions; Installation Location; Water Supply; Checking The Bathroom - American Standard SpaLet Advanced Clean 2.5 Manuel D'installation

GROUNDING INSTRUCTIONS

This product should be grounded. In the event of an electrical short circuit, grounding reduces the risk
of electric shock by providing an escape wire for the electric current. This product is equipped with a
cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is
properly installed and grounded.
DANGER– Improper use of the grounding plug can result in a risk of electric shock.
If repair or replacement of the cord or plug is necessary, do not connect the grounding wire to either
fl at blade terminal. The wire with insulation having an outer surface that is green with or without yellow
stripes is the grounding wire.
Check with a qualified electrician or serviceman if the grounding instructions are not completely
understood, or if in doubt as to whether the product is properly grounded.
This product is for use on a nominal 120 V circuit, and has a grounding plug that looks like the plug
illustrated in sketch A. A temporary adapter, which looks like the adapter illustrated in sketches B and
C, may be used to connect this plug to a 2-pole receptacle as shown in sketch B if a properly grounded
outlet is not available. The temporary adapter should be used only until a properly grounded outlet
(sketch A) can be installed by a qualifi ed electrician. The green colored rigid ear, lug, and the like
extending from the adapter must be connected to a permanent ground such as a properly grounded
outlet box cover. Whenever the adapter is used, it must be held in place by the screw.

Installation Location

In order to prevent damage to the electronic components, install this product at a location that
minimizes the possibility of it getting wet. In extremely humid conditions, provide adequate ventilation by
operating an exhaust fan or opening a window or door.

Water Supply

Use only the tap water line to supply water to this product. The use of any other type of water i.e. ground
water or well water may reduce functionality of product.The tap water pressure must be 8.5 to 106.7 psi
(0.06 to 0.74 MPa, 0.6 to 7.5 kgf/cm

Checking the Bathroom

The dimensions required for mounting this product on a toilet are shown in the fi gure below. Check to
make sure there is sufficient space inside the bathroom and that there are no obstructions.
7-13/16˝
(199mm)
15-5/8˝
(397mm)
9-3/16˝
(233mm)
5-1/4˝
(133mm)
2 ).
11-1/4˝ 2-3/16˝
(285mm) (55mm)
7-15/16˝
(202mm)
Remote receiver
GROUNDED
OUTLET
A
GROUNDING PIN
14-7/8˝
(378mm)
7 - EN -

GROUNDING

METHODS
ADAPTER
METAL
SCREW
GROUNDED
OUTLET
BOX
METAL SCREW
B
TAB FOR
C