Other Convenient Functions; Night Light - American Standard SpaLet Advanced Clean 2.5 Manuel D'installation

Other convenient functions

 Night light
®
SpaLet seat is equipped with night light, which can be enabled when necessary.
1. To turn on night light, press [Night Light] button on the remote Control.
2. To turn off night light, press [Night Light] button on the remote Control.
 Remote Control signal settings when multiple units are installed side by side
When installed side by side, other SpaLet
and take that action. In this case, please change the signal used by the remote control.
1. Change transmission signal of remote control
(1) Remove batteries of remote control
(2) According to signal table in the following figure, press corresponding button while installing batter-
ies, and hold for 6 seconds. (Signal 6, signal 7 may be 20 seconds.)
(3) When transmission signal changes, battery indicator of remote control will flash accordingly.
(Flashing times of battery indicator vary with the corresponding signal change.)
Signal number
Signal 1
Signal 2
Signal 3
Signal 0
Signal 4
Signal 5
Signal 6
Signal 7
Factory setting is [Signal 0]
®
2. SpaLet seat receiving signal change
(1)Temporarily unplug the power plug of the SpaLet
(2)Then, insert the power plug, and press Stop button continuously for more than 10 times within 10
seconds.

[Night Light]

®
seat may receive signal from remote control of this product
Operation switch
Water Temp
Seat Temp
Power Saving
Nozzle Cleaning
Spray Strength +
Spray Strength -
Cleansing
Bidet
25 - EN -
Flashing times of battery indicator
1 time
2 times
3 times
4 times
5 times
6 times
7 times
8 times
®
seat that needs to change signal