Cleaning Areas Covered By The Toilet Seat Lid & Unit - American Standard SpaLet Advanced Clean 2.5 Manuel D'installation

Cleaning Areas Covered by the Toilet Seat Lid & Unit
CAUTION When cleaning this product, be sure to unplug the power plug from the wall outlet.
The lid can be easily removed, so that the lid and the blocked parts can be cleaned.
Remove lid
Hold the lid with both hands and pull the
pin hole on the right of the lid outwards so
as to separate it from the pin and tilt it up.
Lid
1 Hold with both hands
2 Pull it outwards
1. Remove the power plug from the wall outlet.
2. Close the water shutoff valve to cut off the water supply.
3a. Push the lock lever on the right side of the seat unit.
3b. Pull from base of seat, slide the seat forward by
grasping at base, raise it slightly and remove from toilet.
* When removing this product, slide the unit slowly without
holding the toilet seat or toilet seat lid. Do not use
excessive force.
4. Carefully place the seat unit on the rim of the toilet
bowl.
5. To reinstall seat, slide it back on mounting pad.
CAUTION
When cleaning the toilet
bowl, take care not to splash
the seat unit with detergent.
Before installing the seat
unit, wipe the detergent off
from the toilet bowl using a
cloth damped with water.
Pin hole
Pin
Removing the seat unit
Lift the lid and move it to the left and then
remove it.
2 Move it to the left
[CAUTION]
Risk of lid damage.
Risk of scratches or damage to the lid.
Slide
forward
31 - EN -
Lid
1 Lift the lid
3b
Slide
forward
Lock lever
3a