Cleaning The Inlet Strainer - American Standard SpaLet Advanced Clean 2.5 Manuel D'installation

Cleaning the Inlet Strainer

If the water pressure weakens over time, clean the strainer using the following procedure.
Cleaning the Inlet Strainer
1. Close the water shutoff valve to cut off
the water supply.
NOTE: Since the water shutoff valve is adjusted
beforehand, keep track of the turns so that you can
return to the original position.
2. Turn the strainer located on the bottom
left of the seat unit using a screwdriver or
similar tool and remove it.
When the strainer is removed, a small amount of water
will pour out. Place a wash bowl or similar container
underneath to catch the water.
Strainer
Turn counterclockwise.
3. Remove the dirt adhering
to the inside of the strainer
by rinsing it with water.
4. Install the strainer, tightening it fully with a
screwdriver or similar tool.
Tighten the strainer until
the end is completely
inside the seat unit.
5. Open the water shutoff valve by turning
the water shutoff valve back to its original
position.
6. Finally, perform an operational check.
30 - EN -