Setup; Ac Power; Ac Plug; Power Linking - Chauvet Professional F3 Mode D'emploi

3. Setup

AC Power

Each F3 has an auto-ranging power supply that works with an input voltage range of 100 to 240 VAC, 50/
60 Hz. To determine the power requirements for each F3, refer to the label affixed to the product. You can
also refer to the Technical Specifications
The listed current rating indicates the maximum current draw during normal operation. For more
information, download Sizing Circuit Breakers from the Chauvet website: www.chauvetprofessional.com.
• Always connect the product to a protected circuit (circuit breaker or fuse). Make
sure the product has an appropriate electrical ground to avoid the risk of
electrocution or fire.
• To eliminate unnecessary wear and improve its lifespan, during periods of non-use
completely disconnect the product from power via breaker or by unplugging it.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even if
the rheostat or dimmer channel serves only as a 0 to 100% switch.

AC Plug

Each F3 comes with a power linking cord to connect power between panels and a power test cable.
The test cable has a Seetronic Powerkon
input. Use the table below as a reference to wire a new plug.
Connection
AC Live
AC Neutral
AC Ground

Power Linking

Power
Source
All F3 panels support power linking. Refer to the following table for specifications on each panel.
Please refer to all applicable local codes and regulations for the proper installation
of this product.
7
chart in this manual.
®
connector to connect to the F3 and an Edison plug for power
Wire (U.S.)
Black
White
Green/Yellow
st
1 Product
Voltage
@ 120 V, 60 Hz
@ 208 V, 60 Hz
@ 230 V, 50 Hz
Wire (Europe)
Brown
Blue
Green/Yellow
nd
2 Product
rd
3 Product
Additional Products
F3 Products
8
14
15
F3 User Manual Rev. 4
Setup
Screw Color
Yellow or Brass
Silver
Green