Connecting (Cabling) Each F3; Testing Signal And Power Connections; Using The F3 Test Button - Chauvet Professional F3 Mode D'emploi

6. Connecting (Cabling) Each F3

Testing Signal and Power Connections

Each F3 has 2 power sockets and 2 signal ports.
• The Power and Signal connections are located on the underside of the service module of each
panel.
• The Signal ports may be used interchangeably.
• Each F3 has LED indicator lights on the test button in the center of the panel.
• Each panel indicates a successful power connection when the Power indicator light remains red.
• Each panel indicates the presence of a signal when the Signal LED indicator light blinks green
quickly. When the LED blinks green slowly, there is no signal.
Rear Panel View

Using the F3 Test Button

Each F3 has a Test button, used to ensure all LEDs are functional. Use the Test button on each panel to
perform a self-test. If self-testing, you must perform the test individually for each F3. You do not need to
connect to a signal or use software.
When using the Test button, make sure the F3 is NOT connected to the VIP Drive 43Nova.
To use the Test button, you must connect the power, but do not connect the signal cables. Press the Test
button to toggle through various LED light display configurations.
17
Connecting (Cabling) Each F3
Underside of Service Access View
Signal Connections
Test Button
Power/Signal
Indicator LEDs
Power In/Out
F3 User Manual Rev. 4