LED Module Care and Replacement
7. LED Module Care and Replacement
F3 Module
Each F3 has 4 LED modules connected to the panel frame by magnets. Each module has a single
connector that connects to the main processing unit.
LED Lot Numbers
To ensure consistent color matching and output, replace damaged or defective modules with the same
LED lot # as the others on the panel. When combining panels to create full video wall systems (rentals,
permanent installations, etc.) it is highly recommended that the LED lot #'s on each of the panels match.
LED lot #'s can be located on the back of each module.
Connector
LED LOT #
Steel Plate
(x2)
A and B Modules
The F3 has 2 types of modules, designed to only plug in to the Service Module from one direction. Check
the orientation of the LED LOT # label to determine whether the module is an A type (top half, connector
down) or a B type (bottom half, connector up).
Using MT-03
Slide latch to release/
retract magnets
Squeeze to attach
magnets to module
Roll to remove
from module
Magnet (x2)
The MT-03 is specially designed to carefully remove and replace the F3 LED module from the front while
the panel is mounted in a video wall setup. Before using this tool, be sure to familiarize yourself with how
this tool works by reading all the module removal/installation procedures.
F3 User Manual Rev. 4
20