Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Connecting (Cabling) Each F3
Connecting Power and Signal Cables
The following sections provide information and diagrams on connecting signal and power between panels.
Refer to the
Introduction
or
Connecting the Signal Between Joined Panels
Signal cable panel connections can use several different configurations. The basic configuration to
connect the signal from one panel to the next is as follows:
1.
The source signal is connected to the first panel.
2.
A signal cable is then connected from the first panel.
3.
The connections continue to daisy-chain until all panels are connected.
4.
The route of the cables used to make the signal connections can vary.
The following diagram is a recommended suggestion for simple signal connections between panels.
Video Signal
VIP Drive 43Nova
F3 User Manual Rev. 4
Operation
sections in this User Manual for available cables and item numbers.
Signal Jumper Cable
Etherkon connection to
the first F3 in the series
Video Signal Cable in from
VIP Drive 43Nova maximum
cable length 100 m/328 ft
May be used to run a backup
line to the VIP Drive 43Nova
18
Publicité
Table des Matières
