Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Mounting
4. Mounting
Orientation
Each F3 is constructed of magnesium die-cast. This ensures each panel is stable and easy to install. Each
panel also has convenient built-in handles located on the sides of the backside of the panel along with two
alignment conicals on the top. This combination enables you to easily pick up and securely hold each
panel while mounting and working with the panels.
The F3 can be assembled to provide any number of modular designs. The panels on the top can be
securely hung from a truss or other stable surface. Always hang in a safe position with adequate space for
ventilation, configuration, and maintenance.
Chauvet recommends following the general guidelines below.
•
When selecting an installation location, consider ease of access for operation and routine
maintenance.
•
Make sure to hang away from any flammable material, as indicated in the
•
Never mount in places where rain, extreme temperature changes, or restricted ventilation may
affect it.
•
Make sure that the structure and attachment points to which you are hanging the panels can support
the weight.
•
Make sure that all load-bearing hardware used can support the weight.
•
See the
Technical Specifications
Mounting Points
1
2
2
2
1
3
1. Threaded Mounting
Holes Size M12 (x4)
F3 User Manual Rev. 4
for the weight requirement of each F3.
2
3
2. Male Speego
Connection
Safety Notes
section.
2
1
3
3
3
1
3. Female Speego
Connection
8
Publicité
Table des Matières
