Typical F3 Installation - Chauvet Professional F3 Mode D'emploi

Typical F3 Installation

9. Typical F3 Installation
Because a video wall system can include different components to provide a simple to complex modular
wall design, use the following steps as a general guide to get started.
Step 1
Open and examine the F3 road case to make sure you have received all products and accessories and
that each one is in good condition.
Step 2
Apply power and run the self-test for each F3 to ensure all LEDs and inside connections in each panel are
working (optional).
Step 3
Create a stable mounting surface (e.g., truss or other stable surface) for F3 mounting.
Step 4
Mount the first top row of the F3s. Refer to the Mounting section in this User Manual.
Step 5
Adjust the alignment of the first row using the Speego connectors.
Step 6
Connect the signal source to the VIP Drive 43Nova.
Step 7
Connect the VIP Drive 43Nova to the Signal port of the first panel in your connection chain.
Step 8
Based on your video wall configuration (design), join each panel, either horizontally or vertically, using the
instructions in the section Joining Each F3 (Creating a Modular Design).
Refer to the instructions and information in the section of this User Manual, Connecting (Cabling) Each F3.
F3 User Manual Rev. 4 26