Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
Filter Installation
The ÉPIX Strip IP includes a Square Milky Filter already installed. Follow the procedure below to install the included Black
Stealth Filter or Round Milky Filter.
1.
Locate the end cap of the product that does not have the interlocking hardware.
2.
Push in on the end-cap latch.
3.
Slide the installed filter out and replace it with the desired filter.
4.
Release the end-cap latch.
End-Cap Latch
Mounting
Before mounting this product, read the
mounting clamps are capable of supporting the weight of the product. For our CHAUVET Professional line of mounting
clamps, go to http://trusst.com/products.
Mounting Diagram
3
QUICK REFERENCE GUIDE
Safety
Notes. Use at least one mounting point per product. Make sure the
Mounting Clamp
Interlocking Hardware
Safety Cable
Safety Loop
Eye Bolts
ÉPIX Strip IP QRG Rev. 4
Publicité
Table des Matières
