Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Vertical Panel Connection
Use the following instructions to join panels vertically:
1.
Line up the alignment conicals at the top of each panel, and the alignment magnets at the top and
bottom of each panel.
2.
Push male Speego connections into female Speego connections.
3.
Turn the spring knobs clockwise 90°.
4.
Turn the tightening latches clockwise 180°, until secure.
Warning! The magnetic attachments are not load-bearing, and are intended for
alignment assistance only. Do not release panel until the hanging hardware has
been fully secured.
15
Joining Each F3 (Creating a Modular Design)
F3 User Manual Rev. 4
Publicité
Table des Matières
