Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
AC Power
This product has an auto-ranging power supply that can work with an input voltage range of 100–240 VAC, 50/60 Hz.
Power Linking
You can link up to 24 COLORado 1 Solo products at 120 VAC, 40 products at 208 VAC, or 45 at 230 VAC. Never exceed
this number. Power linking cords can be purchased separately.
AC Plug
Connection
AC Live
AC Neutral
AC Ground
•
To eliminate unnecessary wear and improve its lifespan, during periods of non-use
completely disconnect the product from power via breaker or by unplugging it.
•
When using this product in an outdoor IP65 type environment, be sure to use IP65 (or higher)
rated power cables and secure unused ports with attached IP65 covers.
DMX Linking
The COLORado 1 Solo will work with a DMX controller using a 3- or 5-pin DMX serial connection. A DMX Primer is
available from
www.chauvetprofessional.com.
DMX Connection
The COLORado 1 Solo uses a 3- or 5-pin DMX data connection for its DMX personalities: STD.Y, TOUR, TR16, SSP and
HSIC. See the User Manual for information about connecting and configuring the product for DMX operation.
When using this product in an outdoor IP65 type environment, be sure to use IP65 (or higher) rated
data cables and secure unused ports with attached IP65 covers.
Note: For optimum control of the 16-bit dimming channels in the TR16 and STD.Y personalities, be
sure that both dimming curves in SETTING > DIMMER are set to OFF
Master/Slave Connection
The COLORado 1 Solo uses the DMX data connection for its Master/Slave mode. See the User Manual for information
about how to connect and configure the product for master/slave operation.
COLORado 1 Solo QRG Rev. 7
QUICK REFERENCE GUIDE
Wire (U.S.)
Black
White
Green/Yellow
Wire (Europe)
Brown
Blue
Green/Yellow
EN
Screw Color
Yellow/Brass
Silver
Green
2
Publicité
Table des Matières
