Dmx Linking - Chauvet Professional OVATION E-910FC Mode D'emploi

Ovation E-910FC QRG
AC Power
Power Linking
AC Plug
Replacing The
Fuse

DMX Linking

DMX Connection
Master/Slave
Connection
RDM
(Remote
Device
Management)
This product has an auto-ranging power supply that can work with an input voltage
range of 100–240 VAC, 50/60 Hz.
You can link up to 6 Ovation E-910FC products at 120 V, 11 products at 208 V, or
12 products at 230 V. Never exceed this number. Power linking cords can be
purchased separately.
Connection
AC Live
AC Neutral
AC Ground
To eliminate unnecessary wear and improve its lifespan, during periods of
non-use completely disconnect the product from power via breaker or by
unplugging it.
1. Disconnect this product from power.
2. Using a flat head screwdriver, unscrew the fuse holder cap from the housing.
3. Remove blown fuse and replace with a good fuse of the same type and rating.
4. Screw the fuse holder cap back in place and reconnect power.
The Ovation E-910FC will work with a DMX controller using a 3- or 5-pin DMX
serial connection.
www.chauvetprofessional.com.
The Ovation E-910FC uses a 3- or 5-pin DMX data connection for its DMX
personalities: 3Ch, 5Ch, 7Ch, 10Ch, 12Ch, 13Ch, and 15Ch. See the User
Manual for information about connecting and configuring the product for DMX
operation.
The Ovation E-910FC uses the DMX data connection for its Master/Slave mode.
See the User Manual for information about connect and configure the product for
master/slave operation.
Remote Device Management, or RDM, is a standard for allowing DMX-enabled
devices to communicate bi-directionally along existing DMX cabling. The
Ovation E-910FC supports RDM protocol that allows feedback to monitor
temperature and changes to DMX Address and DMX Channel menu map
options. Download the User Manual from
details.
Wire (U.S.) Wire (Europe)
Black
White
Green/Yellow Green/Yellow
A DMX Primer
www.chauvetprofessional.com
3
Screw Color
Brown Yellow/Brass
Blue Silver
Green
is available
EN
from
for more