Setup; Ac Power; Ac Plug; Power Linking - Chauvet Professional PVP X6IP Mode D'emploi

3. Setup

AC Power

AC Plug

Power Linking

PVP X6IP User Manual, Rev. 4
Each PVP X6IP has an auto-ranging power supply that works with an input voltage
range of 100–240 VAC, 50/60 Hz. To determine the power requirements for each
PVP X6IP, refer to the label affixed to the product. You can also refer to the
Specifications chart in this manual.
The listed current rating indicates the maximum current draw during normal operation.
For more information, you may download Sizing Circuit Breakers from the Chauvet
website: www.chauvetprofessional.com.
· Always connect this product to a protected circuit with an appropriate
electrical ground to avoid the risk of electrocution or fire.
· To eliminate unnecessary wear and improve its lifespan, during periods of non-
use completely disconnect the product from power via breaker or by
unplugging it.
Never connect this product to a rheostat (variable resistor) or dimmer circuit, even
if the rheostat or dimmer channel serves only as a 0 to 100% switch.
Each PVP X6IP comes with a power linking cord to connect power between panels and
a power input cord.
This cable has a Seetronic Powerkon connector to connect to the PVP X6IP and an
Edison plug for power input. Use the table below as a reference to wire a new plug.
Please note that Seetronic Powerkon IP65 and Neutrik powerCON TRUE1
connectors are interchangeable.
Connection
AC Live
AC Neutral
AC Ground
All panels in the PVP Series support power linking. Refer to the following table for
specifications on each panel.
@ 120 V, 60 Hz
@ 208 V, 60 Hz
@ 230 V, 50 Hz
Please refer to all applicable local codes and regulations for the proper installation
of this product.
Wire (U.S.) Wire (Europe)
Black
White
Green/Yellow Green/Yellow
Screw Color
Brown Yellow or Brass
Blue Silver
Green
PVP X6IP
17
28
29
Setup
Technical
7