Mounting; Orientation; Opening And Closing The Louvers - Chauvet Professional PVP X6IP Mode D'emploi

Mounting

4. Mounting

Orientation

Opening and
closing the louvers
8
Each PVP X6IP is constructed of aluminum die-cast. This ensures each panel is stable
and easy to install. Each panel also has a convenient built-in handle located on the top,
backside of the panel along with an alignment nipple on the top. This combination
enables you to easily pick up and securely hold each panel while mounting and working
with the panels.
The PVP X6IP can be assembled to provide any number of modular designs. The panels
on the top can be securely hung from a truss or other stable surface. Always hang in a
safe position with adequate space for ventilation, configuration, and maintenance.
Chauvet recommends following the general guidelines below.
· When selecting an installation location, consider ease of access for operation and
routine maintenance.
· Make sure to hang away from any flammable material, as indicated in the
Notes section.
· Never mount in places where rain, extreme temperature changes, or restricted
ventilation may affect it.
· Make sure that the structure to which you are hanging the panels can support the
weight.
See the Technical Specifications
Each PVP X6IP is equipped with 4 modules. Each module is equipped with louvers that
when open allow
8% transparency. When using the panel outdoors, it is highly recommended that the
louvers remain open to allow wind to flow through the panel and reduce wind forces on
the structure the panels are attached to.
To open and close the louvers, simply pull the louver knob back while moving it up or
down.
Louver Knobs
When using the panel outdoors, it is highly recommended that the louvers remain
open to allow wind to flow through the panel and reduce wind forces on the
structure the panels are attached to.
for the weight requirement of each PVP X6IP.
air to flow through
Safety
the panel and create
PVP X6IP User Manual, Rev. 6
an