Fitting The Transmitter On The Sensor; Fitting The Transmitter On A 35-Mm Din Top Hat Rail - ABB TH01 Notice D'utilisation

2.4.2
PG 16
S
M 24 x 1.5
Fig. 2-4
2.4.3
Fitting on a 35 mm top hat rail
(Dimensions in mm/inches)
The transmitter is screwed onto the base with the
fastening screw and then clamped onto the top hat rail.
Messumformer/Transmitter/Transducteur
Fig. 2-5
3KDE115000R4284 Temperature Transmitter TH01, TH01-Ex, TH101, TH101-Ex
TH01/TH01-Ex temperature transmitter for sensor probe assembly

Fitting the transmitter on the sensor

44
Fitting the standard model
(Sensor and transmitter rotated by 90°
in diagram)
M = Sensor flange plate
S = Toothed discs

Fitting the transmitter on a 35-mm DIN top hat rail

Hat rail mounting
Fastening screw
M4 x 23
Automation Products
TH01
44/1,73
Base
35/1,38
Fitting on a 35 mm top hat rail with base
Assembly on sensors without riveted sleeves and
springs
(e.g. DIN-B junction head)
Sensor connection wire approx. 50 mm long and
insulated.
Note
22,5
M
Put in the toothed discs (S) with the convex side facing
up. Tighten the fastening screws.
Pressing the toothed discs (S) between the sensor
flange plate (M) and the base of the junction head
ensures a permanent, firm connection between the
transmitter and the sensor.
Sensor assembly set
S
Order number 215882
(2 fastening screws, 2 springs, 2 toothed discs)
Dimensional drawing of base
(Dimensions in mm/inches)
Fig. 2-6
Required spare part:
Base for all temperature transmitters for sensor probe
assembly
Order number: 7957 786
Threaded hole
M4
50/1,94
Dimensional drawing of base
27