Water Temperature; Rinse Agent; Problem Solver - GE GSD2204PWW Guide D'utilisation Et D'entretien

PROBLEM
SPOTS AND FILMING ON
GLASSES AND FLATWARE
CLOUDINESS ON GLASSWARE
CHIPPING OF CHINA
BLACK OR GRAY MARKS ON
DISHES
SMALL AMOUNT OF WATER STAN-
DING IN THE BOTTOM OF THE TUB
22
QUESTIONS ? QUESTIONS ?
USE THIS PROBLEM SOLVER USE THIS PROBLEM SOLVER
POSSIBLE CAUSE
Spotting can be caused by all these things :
• Extremely hard water. (See How to Choose and Use Detergent
section Page 9.)
• Low inlet water temperature. (See How to Test Water
Temperature Section Page 8.)
• Overloading the dishwasher.
• Improper loading. (See Loading section Page 10.)
• Old or damp powder detergent.
• Phosphate level in detergent too low. (See How to Choose and
Use Detergent section Page 9.)
• Rinse agent dispenser empty. (See How to Use a Rinse Agent
section Page 8.)
• Too little detergent. (See How to Choose and Use Detergent
section Page 9.)
Local water conditions and personal preferences vary. Try
several brands of detergents to find one that gives the best results
for you. A liquid dishwasher detergent may help reduce filming.
To remove stubborn spots and film from glassware:
1. Remove all metal utensils from the dishwasher.
2. Do not add detergent.
3. Select POTS AND PANS cycle or HEAVY.
4. Start the dishwasher and allow to run for 18 to 22 minutes.
The dishwasher will now be in the main wash.
5. Then open the door and pour 2 cups (500 ml) of white
vinegar into the bottom of the dishwasher.
6. Close the door and allow to complete the cycle.
If vinegar rinse doesn't work : Repeat as above, except use 1/4
cup (60 ml) of citric acid crystals instead of vinegar (Most
drugstores carry citric acid crystals. If yours doesn't, call Service
Parts).
Using a vinegar or citric acid crystal rinse more than twice a
month ? Consider a home water softener.
If vinegar or citric acid crystal rinse doesn't work, the cloudiness
is "etching."
The film cannot be removed.
It can be prevented : Use less detergent if you have soft water.
Wash glassware in the shortest cycle that will get them clean.
Water temperature entering the dishwasher exceeds 63°C (150°F).
Rinse agent dispenser empty (See page 8).
Rough handling can cause chipping. Load with care. Make sure
glassware and china are secure and can't jar loose. (See Loading
section Page 10). Make sure tall glasses and stemware will clear
the top of the tub when you push the rack into the dishwasher.
Always use the top rack for delicate items.
Aluminum utensils often leave marks when they rub against
dishes. Remove marks with a mild abrasive cleanser.
Water around the outlet on the tub bottom at the back of the tub is
normal. It is clean water. It's there to keep the water seal lubricated.