GE GSD2204PWW Guide D'utilisation Et D'entretien page 19

INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS
Step 15. Pre-test check list
Check to be sure power is off.
Open dishwasher door and remove all foam
packaging.
Read the Use & Care manual to familiarize
yourself with the operation of the
dishwasher.
Add two quarts of water to the bottom of the
dishwasher to lubricate the pump seal.
Remove the protective film if present from
the control panel, trim and door.
Check to be sure that wiring is secure under
the dishwasher. Reattach connections if
necessary.
Pull lower rack about half way out. Check to
be sure it does not roll back into dishwasher
or further out. If it does, relevel dishwasher.
Turn on water supply.
Check for plumbing leaks. Tighten
connections if necessary.
Turn on the hot water faucet at the sink.
Verify that temperature is at least 120°F.
Adjust the water heater to deliver water
between 120°and 150°F if necessary.
Step 16. Dishwasher wet test check list
Turn on power supply.
Latch door.
Select normal cycle.
On dial models, turn control dial just enough
to start dishwasher. Be careful not to turn
the dial past the first water fill. On
electronic models, push start pad.
Check to be sure that water enters the
dishwasher. This could take up to 4 minutes.
If water does not enter the dishwasher,
check to be sure that water is turned on.
Check for leaks under the dishwasher. If a
leak is found, turn off power supply, tighten
connections and restore power.
Check for leaks around the door. A leak
around the door could be caused by
dishwasher door rubbing or hitting against
adjacent cabinetry. Reposition the
dishwasher if necessary.
The dishwasher will drain about 5 minutes
after the first fill. Check drain lines. If leaks
are found, turn off power, correct as
necessary and restore power.
Let the dishwasher run through another fill and
drain cycle. Check again to be sure there are no
leaks.
At the end of the second drain, push the reset
pad on electronic models. On dial models,
unlatch the door and rotate the dial clockwise to
the "OFF" position.
Step 17. Replace access panel and toekick
Refer to Figure U. Place the toekick against the legs
of the dishwasher. Align the access panel to the
dishwasher. Align the toekick and make sure the bottom
edge is against the floor. Insert and tighten the two
toekick attachment screws, making sure the bottom
edge of the toekick stays in contact with the floor.
WARNING :
Do not swap the screws to
prevent damage to the tub.
Install and Tighten
Attachment Screws
Step 18. Literature
Be sure to leave complete literature package
and installation instructions with consumer.
Step 19 . Silverware basket lid
Silverware basket lid assembly
(certain models only)
Assemble the middle lid. The clip and latch
must be on the opposite side.
Assemble the two small lids at each end. Use
the two fitting holes.
A c c e s s P a n e l
T o e k ic k
Figure U
19