GE GSD2204PWW Guide D'utilisation Et D'entretien page 17

INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS
Step 6. Insert drain hose through
cabinet
Upright dishwasher and position in front of the
cabinet opening. Insert the drain hose into the
hole previously drilled in the cabinet wall. If a
power cord is used, guide the end through a
separate hole cut for the electrical cord.
Figure L
Step 7. Fix the two counter brackets
Fix the two counter brackets on top of the tub
with the two black tapping screws 10-16 x 3/8"
supplied in the user bag. See figure M.
Figure M
Step 8. Slide dishwasher into cabinet
Slide the dishwasher into the opening a few
inches at a time.
As you proceed, pull the drain hose through the
opening and under the sink. Make sure drain
hose is not kinked under dishwasher. Check to
be sure there is no interference with water line
and wiring.
DO NOT PUSH
AGAINST FRONT
DOOR PANEL WITH
YOUR KNEE. Damage
to the door panel will
occur.
Figure N
Step 9. Align water and electrical lines
Route the water line and electrical supply to
their connection locations under the dishwasher.
Do not connect water and electrical in this step.
Step 10. Level dishwasher
Level the dishwasher by adjusting the
four leveling legs individually for
correct alignment. See Figure O.
Dishwasher should be level left to
right and front to back for proper
dish rack operation and dishwasher
performance. Dishwasher door should
be in alignment with adjacent cabinets.
See Figure P.
Step 11. Position dishwasher and fasten
to cabinet
Open the door and position the dishwasher tub
flange 3/4" from the cabinet opening. Fasten the
dishwasher to the underside of the countertop,
using the 2 Flat headed 8-15 x 5/8" screws provided
in the User bag. Be sure screws are driven straight
and flush to avoid interference with door operation.
See Figure P.
Important :
Make sure that
dishwasher is
centered in the
opening and
there is no
interference
with cabinets
when opening
or closing the
door.
Interference
may cause a
water leak when dishwasher is
in operation.
Step 12. Connect water supply
Connect water supply
line to 90° elbow
installed in Step 4.
Figure Q
Figure O
3/4"
Figure P
Hot Water
Supply
90° Elbow
17