GE GSD2204PWW Guide D'utilisation Et D'entretien page 18

Step 13. Connect drain line
Follow all local codes and ordinances.
DRAIN LINE PREPARATION
1. All models are supplied with a pre-attached 78"
long corrugated drain hose. The molded end is
designed to fit 5/8" or 1" diameter connections
to the waste tee or disposer. Cut on premarked line
as required for your installation as illustrated in
Figure R.
Note : DO NOT CUT CORRUGATED PORTION
OF HOSE.
Cut Line
1"
5/8"
Figure R
If the location requires a longer drain hose, add up
to 42" length to the factory installed hose. Use 5/8"
inside diameter hose and thin wall copper coupler
to join the hose ends. Secure connection with
appropriate clamps (not supplied).
Note : TOTAL DRAIN HOSE LENGTH MUST
NOT EXCEED 10 FEET FOR PROPER DRAIN
OPERATION.
DRAIN LINE INSTALLATION
Connect drain line to waste tee or disposer as
previously outlined in "Prepare Drain Plumbing"
section of this manual. Refer to Figure S.
Secure connection using appropriate clamps (not
supplied).
Make sure drain hose is not kinked.
32"
Min.
18"
Min.
Under the sink connection
Hose may be fastened to
underside of countertop
IMPORTANT : TO PREVENT POSSIBLE DRAIN
FROM SINK INTO DISHWASHER OR SIPHONING
OF DISHWASHER WATER, DRAIN LINE MUST BE
ROUTED AS FOLLOWS :
MIN. 30" ABOVE THE FLOOR FOR UNDER THE
SINK CONNECTION.
MIN. 20" ABOVE THE FLOOR FOR INSTALLATION
DIRECTLY THROUGH THE FLOOR.
18
INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS
Do not cut corrugated
portion of hose
Fig. S
20"
Min.
Installation directly
through the floor
Step 14. Connect power supply
Verify that power is turned off at source.
We highly recommend that the PowerCord Kit
#WX09X70910 is used. Please contact Mabe's Part
& Accessories (see Mabe Service section).
If dishwasher is to be directly wired to house
wiring, continue with this step.
• Remove the junction box cover.
• Secure the power supply cable through the
large hole in the back of the junction box with a
strain relief (not supplied).
• Locate the three dishwasher wires (white, black
and green) with the stripped ends which are
going through the small hole in the back of the
junction box. Using UL listed wire nuts, connect
incoming white to white, black to black, and
incoming ground to green wire. (see Figure T)
• Replace the junction box cover.
• Check that wires are not pinched under the
cover.
NOTE : Check that harness
leads are threaded through
small hole in bracket.
Ground
Junction
Box Bracket
If house wiring is not 2-wire as
WARNING
shown in Figure S with a ground
wire, a ground must be provided by
the installer.
When house wiring is aluminum, be
sure to use UL/CSA. recognized anti-
oxidant compound and aluminum-to-copper
connectors.
Check to be sure that wiring is not
WARNING
pinched or in contact with the door
springs.
Figure T
White
Black
Power Cord
(when used)