Troubleshooting - Scheppach DM1000T Traduction Des Instructions D'origine

14. Troubleshooting

Trouble Possible cause
Quality of cut is poor. Cutting tool is dull.
Cutting too aggressively.
Cutting tool is positioned below
workpiece center line.
Lathe speed too slow
Excessive vibration Cutting tool is positioned below
when turning thin work- workpiece centre line.
pieces.
Cutting to aggressively.
Excessive vibration Headstock and/or tailstock improp-
when turning large erly located at ends of workpiece.
workpieces or bowls.
Workpiece is unbalanced.
Lathe will not turnon. Cord not connected into electrical
outlet.
The open door safety switch, located
inside the motor access door panel,
is broken or snapped.
Lathe will not turn off. Damaged or faulty power switch
and/or internal wiring.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Solution
Sharpen or replace cutting tool.
Use a lighter touch.
Lower cutting tool to maximum 3mm above the cen-
tre line of workpiece.
Increase lathe speed
Raise cutting tool to centerline of workpiece.
Use a lighter touch.
Check for proper workpiece centres at headstock
and/or tailstock.
Trim end of workpiece until workpiece is more bal-
anced.
Connect to electrical outlet.
Replace the open door safety switch.
Unplug the lathe from its electrical outlet immediately.
Do not operate lathe until it is repaired by a qualified
service technician.
GB | 27