General Specifications - Velleman DVM860BL Mode D'emploi

b. Display Symbols
Safety issue,
consult the manual
AC or DC
conforms to EU directives
MAX.H
Max. value is being held
4. Maintenance
• Do not remove the back cover while a voltage is being applied. Only a qualified technician should handle repairs.
• Always disconnect the test leads from all current sources before opening the meter.
• Replace the batteries when the
• Replace blown fuses with an identical one or a fuse with identical voltage and current ratings: F 200mA/250V
(quick-acting).
• Use a damp cloth and a mild detergent to clean the device. Never apply abrasives or solvents to the meter
• Place the power switch in the OFF position when the device is not being used
• Remove the batteries to keep them from leaking if the device is to be stored for a long time.
5. Specifications
Max. accuracy is achieved during a one-year period after calibration. Ideal circumstances require a temperature of 18
to 28°C (64 to 82°F) and a max. relative humidity of 75%.

5.1 General Specifications

Sampling Time
Display
Max. Display
Polarity Indication
Overrange Indication
Displayed Measuring Unit
Battery-Low Indication
Maximum Altitude
Max. voltage between terminals and earth
Fuse Protection
Automatic Power Off
Power Supply
Operating Temperature
Storage Temperature
Dimensions
Weight
DVM860BL
AC
Alternating current
Fuse
Diode
DATA-H
Displayed data are held
symbol is displayed.
±0.4sec.
LCD 16mm
1999 points (3 ½ digits)
"-" indicates negative polarity
"OL"
Unit of electrical capacity
" "-symbol is displayed
7000ft (2000m)
600V DC or AC
F 200mA/250V (quick-acting)
15 minutes
3 x 1.5V AAA-battery
0°C to +40°C (+32 to +104°F)
-10°C to +50°C (+10 to +122°F)
158 x 74 x 32mm
±250g (batteries included)
DC
Direct current
Earth ground
Continuity buzzer
AUTO
Automatic range selection
- 2 -
Double insulation
(Protection class II)
/
Battery / Battery low
Measurement with (optional)
clamp
CATIII
Overvoltage category III,
pollution degree 2 (IEC1010-1)
VELLEMAN