Recording A Video - NEC N400i Mode D'emploi

Controlling brightness
☛
With the camera view finder screen displayed, use the
displayed on the left of the status bar area.

Recording a video

Recording a video
To record a video, keep your phone open at all time. Unlike taking a picture, you cannot record a video while the phone is closed.
☛
With the standby screen displayed, press and hold
You can also activate the video camera function by pressing
☛
Look into the view finder screen and adjust the camera position.
You can switch the camera view finder screen between the main-LCD and the 2nd-LCD by pressing .
☛
Press or the Side up key to start recording. The progress bar will show the ratio of how much you have recorded already.
While recording, be careful not to cover the mouthpiece of your phone as it is used as the microphone to record sound along with the video.
While recording, the key tones are deactivated.
☛
Move the camera to capture the scenes you want.
☛
Press or the Side up key again, or close your phone to stop the recording.
After the set video file size is reached, the recording automatically stops.
☛
Press Softkey 1 to replay the video. If successfully recorded, press
Pressing the key before/while playing a video file will enlarge the replay screen size, and pressing the
normal.
☛
The video is saved as a 3GPP file in the Videos - My movie folder in My data (see page 68).
The video file will be saved as a file named from the date, month, year, hour, minute and second of the time the recording was completed.
After recording, pressing Softkey 2 will display a message type selection screen to send a mail or MMS with the video file attached (the video file
size must be set to Mail).
For the operations while replaying the video, see "Videos" on page 68.
If a call comes in while you are checking or saving a video, video storage is cancelled. If this occurs, the next time you select camera function a
message appears to say that you have a video that was not stored, allowing you to check and store the video.
Before recording a video, you can switch to the camera function by pressing Softkey 2. This use of Softkey 2, however, is invalid if the self-timer
function is activated.
64
and keys to control the brightness level of the picture. The current brightness level is
to activate the video camera function.
5 and 2 from the standby screen.
.
key will return the screen size to