Taking A Picture; Using The Light - NEC N400i Mode D'emploi

Copyright information
Images and videos shot or recorded on your phone cannot be used in ways that infringe copyright laws without the consent of the copyright holder,
unless intended only for personal use. Note that some restrictions apply to the photographing of stage performances, entertainments and exhibits,
even when intended purely for personal use.
Users are also asked to note that the transfer of images protected under copyright laws is only permissible within the restrictions imposed by those
copyright laws.
Be considerate of other people's privacy when you take a picture or record a video using the camera of your phone and send it to others.

Taking a picture

Taking a picture
☛
With the standby screen displayed, press
You can also activate the camera function by pressing
☛
Look into the camera view finder screen and adjust the camera position to place the target on the screen.
You can switch the camera view finder screen between the main-LCD and the 2nd-LCD by pressing .
☛
Hold the camera still, and press
☛
Check the picture. If successfully taken, press
☛
The picture is saved as a JPEG file in the Pictures folder (see page 67).
The default file name for the picture is the date, month, year, hour, minute and second from the date and time settings of your phone.
After taking a picture, pressing Softkey 2 will display a message type selection screen to send a mail or MMS with the picture file attached.
If a call comes in while you are checking or saving a photographed image, image storage is cancelled. When this occurs, the next time you select
camera function a message appears to say that you have an image that was not stored, allowing you to check and store the image.
Before taking a picture, you can switch to the video camera function by pressing Softkey 2. This use of Softkey 2, however, is invalid if the self-timer
function is activated.

Using the light

☛
With the camera view finder screen displayed, press Softkey 1 to turn the light on or off.
Take care not to hold the light too close to your or other people's eyes when the light is lit.
Zoom
☛
With the camera view finder screen displayed, press the ▲ or ▼ key to zoom in and out.
to activate the camera function.
5 and 1 from the standby screen.
or the Side up key.
.
63