Electrical Specifications; Section 3. Installation Instructions; For Your Safety; Materials And Tools - Zodiac Nature2 Fusion Soft Manuel D'installation Et De Fonctionnement

Page 10
ENGLISH
2.4

Electrical Specifications

Circuit Protection If only the Nature
Soft is connected to the circuit
breaker, use a 5 AMP fuse. If
more devices are connected
to the circuit breaker use a
20 AMP fuse at the electrical
panel.
Nature
2
to FUSIONM
Input 120 VAC, 50/60 Hz, 2.5 AMPS
240 VAC, 50/60 Hz, 1.25 AMPS
Output 22-30 VDC @ 6 AMPS maximum
Chlorine 600 gm / day (1.32 lb / day)
External ORP/External Control Connector
Control Option AquaLink RS485 Connector
CAUTION
The FUSIONM saltwater chlorinator electronics
are factory wired for 240 VAC service. If the
available electrical service is 120 VAC, then the
power supply wiring must be changed to operate on
120 VAC as shown in Figures 10 and 12.
• The chlorinator electronics are powered from the
LOAD SIDE of the pool circulation pump relay;
therefore, if the available electrical service is 120
VAC, then the pump must also be wired for 120
VAC.
Section 3. Installation
Instructions
WARNING
FOR YOUR SAFETY: This product must be installed
and serviced by a professional pool/spa service
technician as described on the front cover of this
manual. The procedures in this manual must be
followed exactly. Failure to follow warning notices
and instructions may result in property damage,
serious injury, or death. Improper installation and/or
operation will void the warranty.
Zodiac Nature
®
Fusion
2
Fusion Soft 1400C Connected
|
Fusion Soft Installation and Operation Manual
2®
When using electrical products, basic precautions
should always be followed, including the following:
• RISK OF ELECTRIC SHOCK WHICH CAN
RESULT IN SERIOUS INJURY OR DEATH.
Before attempting installation or service, ensure
that all power to the device is disconnected/
turned off at the circuit breaker.
• Grounding is required. The unit should be
installed by a qualified service representative and
should be properly grounded and bonded. (See
Section 3.8, Grounding and Bonding).
• Install to permit access for servicing.
• Read Section 1, Safety Information.
Before attempting any electrical wiring, be
sure to read and follow Safety Instructions.
Wiring should only be attempted by a qualified
professional.
3.1

Materials and Tools

NOTE Salt not included. See Section 4, Pool Water
Preparation.
Materials Furnished for Installation
Nature Fusion Soft
2
Vessel with 5 - 6.3 cm (2"-2½") Universal Unions
Sensor with 4.88 m (16 ft) Cable and O-ring
Universal Union Nut (to secure sensor)
4.88 m (16 ft) DC Power Cord
Installation and Operation with Warranty Information
FUSIONM Power Pack (Sold separately)
Power Pack Housing with User Interface Control
Two (2) Wire Nuts
Installation Template
PureLink with Power Center (Optional - Sold
TM
separately)
AquaLink RS PureLink power center (Standard or
®
Breaker)
Two (2) Wire Nuts
Installation Template
WARNING