Bypass Installation; Figure 4. Example Of Nature Fusion Soft - Zodiac Nature2 Fusion Soft Manuel D'installation Et De Fonctionnement

Nature Fusion Soft
2
Flow
Figure 4. Example of Nature
3.5

Bypass Installation

If plumbing size is greater than 5 cm (2") diameter or
if flow rates are greater than 450 lmp (120 gpm), the
vessel MUST be plumbed on by-pass (see Figure 5). It
is recommended that 5 cm (2") PVC Schedule 40 pipe is
used to plumb the by-pass line. A control valve must be
installed to regulate the flow through the vessel. It can
be installed on the inlet side of the vessel or between the
inlet and discharge side of the bypass piping.
1. Make sure the pool pump is turned off.
2. Install the Nature 2 cartridge.
3. Locate a suitable section of pipe in the by-pass line
to install the vessel, approximately 43 cm (17")
long, that conforms to the installation requirements
outlined in Section 3.2.
4. Cut out a 35 cm (13
pipe to insert the vessel (see Figure 3).
|
Zodiac Nature Fusion Soft
® 2®
Heater
Flow
Flow/Temperature/
Salinity Sensor
Fusion Soft Installation With Options
2
/ ") section of the 5 cm (2")
7
8
Installation and Operation Manual
Optional ChemLink or
other ORP Control
Flow/Temperature/
Salinity Sensor
Pool Return
5. Install tees in the return line to allow water to be
diverted to the Nature
6. Connect the bypass line from the first tee to the
inlet of the vessel and from the outlet of the vessel
to the second tee.
7. Install a control valve in the return line between
the first and second tee or prior to the vessel
inlet on the bypass line to control the water flow
through the bypass.
8. Hand tighten all unions, sensors, and collars.
Be careful not to get finger caught between inlet
union and plug when tightening as this may cause an
injury.
ENGLISH Page 13
FUSIONM
or
APUREM
or
PureLink
TM
or
Existing AquaPure
®
k
Power Pac
Filter
Pool Intake
Spa Intake
Spa Return
Fusion Soft vessel.
2
CAUTION
Pump