Table des Matières
Publicité
HULL
HOOD
HANDLEBAR
SERVICE POINTS
Handlebar inspection
1. Inspect:
Handlebar
Bends/cracks/damage → Replace.
Handlebar switch inspection
Refer to "STARTING SYSTEM" in
chapter 7.
Handlebar assembly installation
1. Install:
QSTS cables
Buzzer lead
Handlebar switch lead
Throttle cable
NOTE:
After inserting the cables and leads into the
grommets, tie the end of grommets with
the bands 1.
2. Install:
Upper handlebar holder 1
CAUTION:
Clearance a should be narrower than
clearance b.
NOTE:
Align the punch mark c on the handlebar
with the top surface of the handlebar
holder.
The upper handlebar holder should be
installed with the punch mark d facing
forward.
8-7
E
Publicité
Chapitres
Table des Matières
