Removing And Emptying The Dust Bin; Cleaning Dust Bin & Filter; Cleaning Main Brushes; Cleaning Vacuum Inlet Cover - Vileda M-488A Guide De L'utilisateur

Removing and Emptying the Dust Bin

G
2
1. Turn off the power switch.
2. Press down the dust bin release button and pull out the dust bin as indicated in illustrations.
3. Empty the dust bin in the rubbish bin.
4. Reinsert dust bin and push until you hear a clicking sound.
Cleaning Dust Bin & Filter
1. Turn dust bin upside down.
2. Press bottom slightly and take filter mesh out as indicated in illustrations.
3. Clear the dirt on the filter mesh.
4. Reinsert filter mesh back to the dust bin.
5. Press slightly until it clicks.
6. Reinsert dust bin in the robot.
Product contains electronic parts. Do not submerge it or spray it with water. Clean with a dry cloth only.
8
C37_2014_08_Cleaning Robot GREY Manual intl_UK Issue: 1 702726
PRESS
4

Cleaning Main Brushes

Main brushes do not need to be cleaned after each use. However, regular cleaning is recommended to avoid
excessive build up of hair that could damage the robot.
1 2
3 5
1. Turn off the power switch and turn the robot upside down on a flat surface.
2. Use a cross-head screwdriver to remove the fixing screw on the right.
3. Take out the main brush, rubber brush and brush coupler together as shown in the illustration.
4. Remove all hair and dirt from both brushes. Clean brushes chamber.
5. Wipe out dirt on the metal shaft and bearing of the brush coupler as indicated in the illustration.
6. Put brush coupler and brushes back.
7. Tighten the screw.

Cleaning Vacuum Inlet Cover

1. Turn off the power switch and turn the robot upside down.
2. Remove vacuum inlet cover as shown in the illustration.
3. Clean vacuum inlet cover and the fan mechanism to ensure good ventilation.
4. Reinsert the vacuum inlet cover by guiding the hinge tabs back into the holes carefully.
G
9