Replacing Side Brush; Troubleshooting; Environmental And Product Recycling; Battery Removal - Vileda M-488A Guide De L'utilisateur

Replacing Side Brush

G
1. Use a cross-head screwdriver to remove side brush cover.
2. Insert new side brush and put back the cover.
3. Tighten the screws.
Problem
Robot does not detect cliffs /
drops.
Robot stops while cleaning and all
light indicators turn on.
Robot stops and battery charge
indicator is on.
Robot only moves in circles in the
same position.
Battery does not recharge.
For further help, technical advice, or for information on spare or replacement parts please contact
Vileda in the UK on 0845 769 7356.

Environmental and Product Recycling

The Vileda Cleaning Robot fulfils the EU directive 2002/96/CE, covering electrical and electronic appliances and
the management of its disposal.
The packaging material is entirely recyclable, and marked with the recycling symbol. Follow local regulations for
scrapping. Keep the packaging materials (plastic bags, polystyrene parts, etc.) out of the reach of children, as
they are potentially dangerous.
When the product has reached the end of its life please do not dispose of it with general household waste.
To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources.
The symbol identifies the Vileda Cleaning Robot as a product submitted to the regime of selective electrical
appliance recycling collection.
10
C37_2014_08_Cleaning Robot GREY Manual intl_UK Issue: 1 702726

Troubleshooting

Possible reason Possible solution
• Sensors are dirty. • Wipe away dust from sensors
with a dry cloth.
• Main brushes are blocked. • Clean main brushes and
restart.
• Main brushes are jammed. • Remove jam and restart.
• Low battery. • Recharge battery.
• One wheel is blocked. • Remove hairs and dirt from
wheels.
• Battery is not installed correctly. • Reinstall battery. Two beeps
should be heard when installed
properly.
• Charger is not plugged correctly. • Check charger is plugged
correctly to the outlet and to
the robot.
The product contains a NiMH battery which should not be disposed of with general household waste. Call, or
deposit the battery in an official collection point for its recycling.
Batteries can be detrimental for the environment and can explode if they are exposed to high temperatures.
The violation of these precautions could cause fire and / or serious injuries.
For more detailed information about treatment, recovery and recycling of this product, please contact your local
city office, your household waste disposal service or the shop where you purchased the product.

Battery Removal

At the end of the product's or battery's life the battery should be removed for disposal and recycling.
Follow these instructions to remove and reinstall the battery:
1. Turn off the power switch and turn the robot upside down.
2. Push both flaps inwards and pull up until battery pack comes out.
3. Reinstall battery by pushing until you hear a clicking sound.
WARNING: NEVER touch both metal battery terminals at the same time with any metal objects as this will short
circuit the battery and may create sparks that can cause small burns.

Technical Specification

Battery type
Charging time
Charger output
Charger input
Unit Average Power
Suction Power
Airflow
Dust Capacity
Unit Size
14.4V DC, 1700 mAh NiMH
4-5 hours
24 V DC
100-240 V AC
19W ~ 25W
3.00W
63.6dm /min
3
0.25 l
34x9 cm
G
11